Acarbose: A New Option in the Treatment of Ulcerative Colitis by Increasing Hydrogen Production

Acarbose，which is clinically widely used to treat Type 2 Diabetes，is thought to act at the small intestine by competitively inhibiting enzymes that delay the release of glucose from complex carbohydrates, thereby specifically reducing post prandial glucose excursion. The major side-effect of treatment with acarbose, flatulence, occurs when undigested carbohydrates are fermented by colonic bacteria, resulting in considerable amount of hydrogen. We propose that enteric benefits of acarbose is partly attributable to be their ability to neutralise oxidative stress via increased production of H2 in the gastrointestinal tract. Therefore, symptoms of ulcerative colitis in human beings can be ameliorated by acarbose

N(HI) and jet power/emission in AGNs

Neutral hydrogen (HI) 21 cm absorption has been detected against more and more powerful radio jets. In this work, based on the Guppta et al. 2006a sample, we present our preliminary study of the correlations between the HI column density N(HI) and the jet power, N(HI) versus the low frequency luminosity at 408MHz, and N(HI) versus the radio luminosity at 1400MHz.Comment: 3 pages, 1 figures, Multiwavelength Variability of Blazars Guangzhou, China, Sept. 22-24, 2010; will be published by JA

Preparation of Ni–YSZ thin and thick films on metallic interconnects as cell supports. Applications as anode for SOFC

In this work, we propose the preparation of a duplex anodic layer composed of both a thin (100 nm) and a thick film (10 lm) with Ni–YSZ material. The support of this anode is a metallic substrate, which is the interconnect of the SOFC unit cell. The metallic support limits the temperature of thermal treatment at 800 C to keep a good interconnect mechanical behaviour and to reduce corrosion. We have chosen to elaborate anodic coatings by sol–gel route coupled with dip-coating process, which are low cost techniques and allow working with moderate temperatures. Thin films are obtained by dipping interconnect substrate into a sol, and thick films into an optimized slurry. After thermal treatment at only 800 C, anodic coatings are adherent and homogeneous. Thin films have compact microstructures that confer ceramic protective barrier on metal surface. Further coatings of 10 lm thick are porous and constitute the active anodic material

Effect of aging on the reinforcement efficiency of carbon nanotubes in epoxy matrix

The reinforcement efficiency of carbon nanotubes (CNTs) in epoxy matrix was investigated in the elastic regime. Cyclic uniaxial tensile tests were performed at constant strain amplitude and increasing maximum strain. Post-curing of the epoxy and its composite at a temperature close to the glass transition temperature allowed us to explore the effect of aging on the reinforcement efficiency of CNT. It is found that the reinforcement efficiency is compatible with a mean field mixture rule of stress reinforcement by random inclusions. It also diminishes when the maximum strain increased and this effect is amplified by aging. The decrease of elastic modulus with increasing cyclic maximum strain is quite similar to the one observed for filled elastomers with increasing strain amplitude, a phenomenon often referred as the Payne effect

First-principles calculations and experimental studies of: XYZ 2 thermoelectric compounds: Detailed analysis of van der Waals interactions

First-principles calculations can accelerate the search for novel high-performance thermoelectric materials. However, the prediction of the thermoelectric properties is strongly dependent on the approximations used for the calculations. Here, thermoelectric properties were calculated with different computational approximations (i.e., PBE-GGA, HSE06, spin-orbit coupling and DFT-D3) for three layered XYZ2 compounds (TmAgTe2, YAgTe2, and YCuTe2). In addition to the computations, the structural, electrical and thermal properties of these compounds were measured experimentally and compared to the computations. An enhanced prediction of the crystal structure and heat capacity was achieved with the inclusion of van der Waals interactions due to more accurate modeling of the interatomic forces. In particular, a large shift of the acoustic phonons and low-frequency optical phonons to lower frequencies was observed from the dispersion-optimized structure. From the phonon dispersion curves of these compounds, the ultralow thermal conductivity in the investigated XYZ2 compounds could be described by a recent developed minimum thermal conductivity model. For the prediction of the electrical conductivity, a temperature-dependent relaxation time was used, and it was limited by acoustic phonons. While HSE06 has only a small influence on the electrical properties due to a computed band gap energy of >0.25 eV, the inclusion of both van der Waals interactions and spin-orbit coupling leads to a more accurate band structure, resulting in better prediction of electrical properties. Furthermore, the experimental thermoelectric properties of YAgTe2, TmAg0.95Zn0.05Te2 and TmAg0.95Mg0.05Te2 were measured, showing an increase in zT of TmAg0.95Zn0.05Te2 by more than 35% (zT = 0.47 ± 0.12) compared to TmAgTe2

Quasi-static stop band with flexural metamaterial having zero rotational stiffness

Metamaterials realizing stop bands have attracted much attentions recently since they can break-through the well-known mass law. However, achieving the stop band at extremely low frequency has been still a big challenge in the fields of elastic metamaterials. In this paper, we propose a new metamaterial based on the idea of the zero rotational stiffness, to achieve extremely low frequency stop band for flexural elastic waves. Unlike the previous ways to achieve the stop band, we found that the zero rotational stiffness can provide a broad stop band at extremely low frequency, which starts from even almost zero frequency. To achieve the zero rotational stiffness, we propose a new elastic metamaterial consisting of blocks and links with the hinge connection. Analytic developments as well as numerical simulations evidence that this new metamaterial can exhibit extremely low and broad stop band, even at the quasi-static ranges. In addition, the metamaterial is shown to exhibit the negative group velocity at extremely low frequency ranges, as well as the quasi-static stop band, if it is properly designed.ope

Localized surface optical phonon mode in the InGaN/GaN multiple-quantum- wells nanopillars: Raman spectrum and imaging

An interesting phonon mode at around 685-705 cm -1 was clearly observed in the Raman spectra of InGaN/GaN multiple-quantum-wells nanopillars with different diameters at room temperature. The Raman peak position of this mode is found to show a distinct dependence on the nanopillar size, which is in well agreement with theoretical calculation of the surface optical (SO) phonon modes of nanopillars. Moreover, this kind of SO phonon was evidenced to be located on the pillar surface by using scanning confocal micro-Raman microscopy. © 2011 American Institute of Physics.published_or_final_versio

Simple and efficient methods for isolation and activity measurement of the recombinant hirudin variant 3 from Bacillus subtilis

A simple purification approach of the recombinant hirudin variant 3 from the Bacillus subtilis was established, by which the hirudin could be purified to the purity of 95% through one-step chromatography with the total recovery rate of 83.9%. A modified Markwardt thrombin titration method for measuring hirudin activity was also set up. Briefly, a series of concentrations of thrombin was prepared and titrated to hirudin sample, respectively and the anti-thrombin activity-range of hirudin was narrowed down by several thrombin solutions at high or low concentration and the optimum group of thrombin concentrations was determined for titration of the hirudin sample. In this modified method, the hirudin activity was determined more accurately, concisely and promptly than the classic Markwardt method.Key words: Hirudin, thrombin titration method, chromatography, purification

Resonance Raman scattering in bulk 2H-MX2 (M=Mo, W; X=S, Se) and monolayer MoS2

published_or_final_versio

Data Fusion of Objects Using Techniques Such as Laser Scanning, Structured Light and Photogrammetry for Cultural Heritage Applications

In this paper we present a semi-automatic 2D-3D local registration pipeline capable of coloring 3D models obtained from 3D scanners by using uncalibrated images. The proposed pipeline exploits the Structure from Motion (SfM) technique in order to reconstruct a sparse representation of the 3D object and obtain the camera parameters from image feature matches. We then coarsely register the reconstructed 3D model to the scanned one through the Scale Iterative Closest Point (SICP) algorithm. SICP provides the global scale, rotation and translation parameters, using minimal manual user intervention. In the final processing stage, a local registration refinement algorithm optimizes the color projection of the aligned photos on the 3D object removing the blurring/ghosting artefacts introduced due to small inaccuracies during the registration. The proposed pipeline is capable of handling real world cases with a range of characteristics from objects with low level geometric features to complex ones